![]() Warning: To avoid pinching hands or fingers, release the riser with caution. ![]() If needed, insert a screwdriver into the lifting slot and pull upward. With the water turned off, you can manually lift the riser. (Do not rotate the screw too far counterclockwise or the nozzle or screw may come out). Turn the screw clockwise (into the stream of water) to decrease the distance or counterclockwise to increase the distance. Insert a screwdriver into the distance adjustment slot (Fig. The adjustment slot will stop turning when adjusted to the minimum spray pattern (40°). Adjust to any spray pattern between 40° and 360°.While holding the nozzle turret at the right stop, turn the screwdriver counterclockwise.The adjustment slot will stop turning when adjusted to the maximum spray pattern (360°).Adjust to any spray pattern between 40° and 360°.While holding the nozzle turret at the right stop turn the screwdriver clockwise.Insert a flat-head screwdriver into the pattern adjustment slot (Fig.(Rotate the turret to test the spray pattern.) The nozzle turret must be held in this position for all spray pattern adjustments. This is the fixed side of the spray pattern. Rotate the nozzle turret clockwise to the right stop.Using the palm of your hand, rotate the nozzle turret counterclockwise to the left stop to complete any interrupted rotation cycle (Fig.It is recommended that the initial adjustment be made before installation. Sprinklers may be adjusted with water on or off. Saturn III® sprinklers are preset to rotate approximately 40°. Below, we explain how to adjust a Gear Drive (Rotor) Sprinkler with a pattern adjustment screw, featuring the Orbit Saturn III® Gear Drive Sprinkler. ![]() In addition to a simple distance adjustment, each gear drive also has a precision filter to make sure no dirt or debris in the water system will clog up your nozzles. All of Orbit’s Gear Drives offer an easy pattern adjustment from 40 to a full 360 degrees. Orbit offers a complete lineup of Gear Drive Sprinklers with spray distances from 15 to 52 feet. Happy watering!ĭiagram of Impact Sprinkler with Deflector Knob How to Adjust a Gear Drive (Rotor) Sprinkler with a pattern adjustment screw (Pro tip – make sure the trip lever is on the outside of the trip-stops).
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |